when is that? over the long weekend? its ok im knee deep in a swap and some other shit, yet again. i hope to be out may long maybe camping locally in cow valley....
well got these old jeep axles sold finally, this is why I hang onto shit.got the jeep all ripped apart, vale cover is all cleaned up and new cork gasket to keep the lube in it, needs a oil change its been running rich for some time now. mocking up exhaust and gotta gasket match the intake to be ok with the head and not cause a loss of power.
so little update for you guys figured out my hinge and latch on the front bumper cover I had shaped out. hinge infront up top and a latch to keep it closed.
I also figured out why my rear drive shaft was never right, the splines on the cv end were fine splines and the tail shaft i had was for large splines, so after buying two semi fucked up shafts with out tail housings I built myself a shorter shaft with proper mating of spline sizes.
oh and a new tool chest for all my misc shit that has been sitting around
when is that? over the long weekend? its ok im knee deep in a swap and some other shit, yet again. i hope to be out may long maybe camping locally in cow valley....
well got these old jeep axles sold finally, this is why I hang onto shit.got the jeep all ripped apart, vale cover is all cleaned up and new cork gasket to keep the lube in it, needs a oil change its been running rich for some time now. mocking up exhaust and gotta gasket match the intake to be ok with the head and not cause a loss of power.
should be around town today, might take the jeep out it needs some time on the open road
Shane I need a Sticker Bro!
so little update for you guys figured out my hinge and latch on the front bumper cover I had shaped out. hinge infront up top and a latch to keep it closed.
I also figured out why my rear drive shaft was never right, the splines on the cv end were fine splines and the tail shaft i had was for large splines, so after buying two semi fucked up shafts with out tail housings I built myself a shorter shaft with proper mating of spline sizes.
oh and a new tool chest for all my misc shit that has been sitting around