Ok cool! Hill 60 it is! Dave is right it looks like there is fun to be had there whenever. Lots of off shoots to see where they go. And the fact that it ties into all those other trails is sweet too!
Party on!
I am down with wherever. It’s all new to me! Lol
Should we try the higher elevation runs? The snow may not be quite as deep as it was a few weeks ago.
Lance you may be the one to fill us in since you were probably the last one to check it out.
What all those guys said and one tip about spraying rads, coolers and condensers (because they do a great job of holding mud, grass, seeds, etc.. lol)
if you are use a pressure washer ( some are more powerful then others, use caution) always hit the fins straight on and don’t hold it too close. Otherwise you will be sitting in front of the rad for a while with a pick restraightening all the fins that run in between the tubes to dissipate the heat. And if they are stubborn and fairly accessible in the vehicle then a garden hose to get a good volume of water soaking from the inside to help back flush the gunk out the opposite way it got jammed in. Also spray nine or something like it works well to soften stuff up too.
And the suds make it look like you are doing something. Haha. When in doubt shine a flashlight through it and see if light comes out the other side. It’s good clue other then a good steady strip of clean water.
And finally if it’s really bad you just suck it up and pull the rads out to really get them clean.
Sorry guys. That was waay shorter in my head then writing it all down!
Cheers!
Sounds great! I’ll meet you there again at the Shell!
Ok cool! Hill 60 it is! Dave is right it looks like there is fun to be had there whenever. Lots of off shoots to see where they go. And the fact that it ties into all those other trails is sweet too!
Party on!
I am down with wherever. It’s all new to me! Lol
Should we try the higher elevation runs? The snow may not be quite as deep as it was a few weeks ago.
Lance you may be the one to fill us in since you were probably the last one to check it out.
Awesome! Thanks guys! The more options to look into the better! I like the thought of the GMRS handhelds. Seem like good bang for the buck.
What all those guys said and one tip about spraying rads, coolers and condensers (because they do a great job of holding mud, grass, seeds, etc.. lol)
if you are use a pressure washer ( some are more powerful then others, use caution) always hit the fins straight on and don’t hold it too close. Otherwise you will be sitting in front of the rad for a while with a pick restraightening all the fins that run in between the tubes to dissipate the heat. And if they are stubborn and fairly accessible in the vehicle then a garden hose to get a good volume of water soaking from the inside to help back flush the gunk out the opposite way it got jammed in. Also spray nine or something like it works well to soften stuff up too.
And the suds make it look like you are doing something. Haha. When in doubt shine a flashlight through it and see if light comes out the other side. It’s good clue other then a good steady strip of clean water.
And finally if it’s really bad you just suck it up and pull the rads out to really get them clean.
Sorry guys. That was waay shorter in my head then writing it all down!
Cheers!